GreenChip SMPS primary side control IC with QR/DCM operation and X-capacitor discharge | NXP Semiconductors

GreenChip SMPS Primary Side Control IC with QR/DCM Operation and X-Capacitor Discharge

Smart Charging Solution

Click over video to play

More

Block Diagram

TEA1936X Block Diagram

TEA1936X Block Diagram

Features

General features

  • SMPS controller IC supporting smart-charging applications and multiple-output-voltage applications
  • Wide output range (5 V to 20 V in CV mode, 3 V to 20 V in CC mode, and 3 V to 6 V in direct charging mode)
  • Housed in a small SO10 package
  • Adaptive dual supply for highest efficiency over the entire output voltage range
  • Integrated high-voltage start-up and X-capacitor discharge
  • Continuous VCC regulation during start-up and protection via the HV pin, allowing a minimum VCC capacitor value
  • Reduced opto current enabling low no-load power (20 mW at 5 V output)
  • Fast transient response from 0 to full load
  • Minimal audible noise and output voltage ripple in all operating modes
  • Integrated soft start

Green features

    Enables high-efficiency operation over a wide power range via:

  • Low supply current during normal operation (0.6 mA without load)
  • Low supply current during the non-switching state in burst mode (0.2 mA)
  • Valley switching for minimum switching losses
  • Frequency reduction with fixed minimum peak current to maintain high-efficiency at low output power levels

Protection features

    All protections are safe to restart protections

  • Mains voltage compensated OverPower Protection (OPP)
  • OverTemperature Protection (OTP)
  • Integrated overpower timeout
  • Integrated restart timer for system fault conditions
  • Continuous mode protection using demagnetization detection
  • Accurate OverVoltage Protection (OVP)
  • General-purpose input for safe restart protection; for use with system OverTemperature Protection (OTP)
  • Driver maximum on-time protection
  • Brownin and brownout protection

NXP GreenChip

  • This product is part of the NXP GreenChip portfolio, this program optimizes for energy efficiency in mobile and computing applications, specializing in high-power density, safety and reliability.

More

Buy/Parametrics

1 result

Include 0 NRND

Order

CAD Model

Status

Package Type

Topology

Supply Voltage [max] (V)

Softstart

Additional Features

Active

SO10

DCM / QR Flyback

120

N

Soft Restart Protection

Documentation

Quick reference to our documentation types.

1-5 of 7 documents

Show All

Design Files

Hardware

Quick reference to our board types.

2 hardware offerings

  • 165W Battery Charger
    Complementary Silicon or Component

    165W Battery Charger

  • 30W Dual Port PD Charger
    Complementary Silicon or Component

    30W Dual Port PD Charger

To find additional partner offerings that support this product, visit our Partner Marketplace.

Software

Quick reference to our software types.

1 software file

Note: For better experience, software downloads are recommended on desktop.