LPC1830FBD144|Arm Cortex-M3|32-bit MCU

For best experience this site requires Javascript to be enabled. To enable on your browser, follow our accessibility instructions.

The LPC1830FBD144 is a high-performance, cost-effective Cortex-M3 microcontroller featuring 200 kB of SRAM, and advanced peripherals including Ethernet, High Speed USB 2.0 Host/OTG/Device and CAN 2.0B. Operating at speeds up to 180 MHz, the LPC1830 also features two new configurable peripherals: a SPI Flash Interface and a State Configurable Timer. All members of the series include a Wakeup Interrupt Controller allowing automatic wake from any priority interrupt as well as four reduced power modes: Sleep, Deep-Sleep, Power-Down, and Deep Power-Down.

See product image

Data Sheet

Application Notes

Product Details

Features

Arm Cortex-M3 processor, running at frequencies of up to 180 MHz
Arm Cortex-M3 built-in Memory Protection Unit (MPU) supporting eight regions
Arm Cortex-M3 built-in Nested Vectored Interrupt Controller (NVIC)
Non-maskable Interrupt (NMI) input
JTAG and Serial Wire Debug
ETM and ETB support
System tick timer
200 kB SRAM for code and data use
32 kB ROM containing boot code and on-chip software drivers
Crystal oscillator with an operating range of 1 MHz to 25 MHz
12 MHz internal RC oscillator trimmed to 1 % accuracy
Ultra-low power RTC crystal oscillator
Clock output
Two PLLs allow CPU operation up to the maximum CPU rate
Quad SPI Flash Interface with four lanes and data rates of up to 40 MB/s
10/100T Ethernet MAC with RMII and MII interfaces and DMA support
One High-speed USB 2.0 Host/Device/OTG interface with DMA support
One High-speed USB 2.0 Host/Device interface with DMA support
Four 550 UARTs with DMA support: one UART with full modem interface
One UART with IrDA interface
One C_CAN 2.0B controller with one channel
Two SSP controllers with FIFO and multi-protocol support
One Fast-mode Plus I2C-bus interface with monitor mode
One standard I2C-bus interface with monitor mode and standard I/O pins
One I2S interface with DMA support and with one input and one output
External Memory Controller (EMC)
SD/MMC card interface
Eight-channel General-Purpose DMA (GPDMA) controller
Up to 83 General-Purpose Input/Output (GPIO) pins
GPIO registers are located on the AHB for fast access
State Configurable Timer (SCT) subsystem on AHB
Four general-purpose timer/counters with capture and match capabilities
One motor control PWM for three-phase motor control
One Quadrature Encoder Interface (QEI)
Repetitive Interrupt timer (RI timer)
Windowed watchdog timer
Ultra-low power Real-Time Clock (RTC) on separate power domain
Alarm timer; can be battery powered
One 10-bit DAC with DMA support and a data conversion rate of 400 kSamples/s
Two 10-bit ADCs with DMA support and a data conversion rate of 400 kSamples/s
Hardware-based AES security engine programmable through an on-chip API
Two 128-bit secure OTP memories for AES key storage and customer use
Unique ID for each device
Single 3.3 V (2.2 V to 3.6 V) power supply with on-chip voltage regulator
RTC power domain can be powered separately by a 3 V battery supply
Four reduced power modes
Overdrive mode to increase CPU and bus clock frequency
Processor wake-up from Sleep mode via wake-up interrupts
Wake-up from Deep-sleep, Power-down, and Deep power-down modes
Brownout detect with four separate thresholds for interrupt and forced reset
Power-On Reset (POR)

Target Applications

Industrial
Consumer
White goods
RFID readers
e-Metering

Buy/Parametrics

‌ ‌ ‌	‌ ‌	‌ ‌	‌ ‌	‌ ‌	‌ ‌
‌ ‌ ‌	‌	‌	‌	‌	‌
‌ ‌ ‌	‌	‌	‌	‌	‌
‌ ‌ ‌	‌	‌	‌	‌	‌
‌ ‌ ‌	‌	‌	‌	‌	‌
‌ ‌ ‌	‌	‌	‌	‌	‌
‌ ‌ ‌	‌	‌	‌	‌	‌
‌ ‌ ‌	‌	‌	‌	‌	‌
‌ ‌ ‌	‌	‌	‌	‌	‌
‌ ‌ ‌	‌	‌	‌	‌	‌
‌ ‌ ‌	‌	‌	‌	‌	‌

Documentation

Quick reference to our documentation types.

1-5 of 27 documents

Data Sheet
32-bit ARM Cortex-M3 flashless MCU; up to 200 kB SRAM; Ethernet, two HS USB, LCD, and external memory controller

PDFRev 6.8Feb 5, 20207.1 MBLPC1850_30_20_10English
Application Note
USBD Library for LPC4300/LPC1800 series MCUs

ZIPRev 1.0Jul 9, 20188.6 MBTN00041English
Application Note
Connecting TFT LCD with LCD controller of LPC MCU

ZIPRev 1Aug 22, 20173.2 MBAN12027English
Application Note
LPC1800 (with Flashless) Low Power Modes and Wake-up Times

ZIPRev 1.0Aug 15, 20161.6 MBAN11853English
Application Note
SCTimer/PWM cookbook

ZIPRev 5.0Mar 22, 201625.5 MBAN11538English, 中文
Application Note
LPC18xx Secondary USB Host bootloader

ZIPRev 1.0Mar 6, 20153.7 MBAN11651English
Application Note
Code Read Protection in LPC1800 and LPC4300

ZIPRev 1.0Aug 14, 201416.6 MBAN11581English
Application Note
Implementing PWM dithering on the LPC18xx SCTimer/PWM

ZIPRev 1.0Aug 8, 20141.7 MBAN11580English
Application Note
SCT camera interface design with LPC1800 and LPC4300

ZIPRev 1.2Jun 12, 20141.4 MBAN11365English
Application Note
AES encryption and decryption software on LPC microcontrollers

ZIPRev 1.1Mar 17, 2014177.9 KBAN11241English
Application Note
SDRAM interface to LPC18xx/43xx EMC

PDFRev 1.0Jan 31, 2014351.0 KBAN11508English
Application Note
Connecting a High Speed USB PHY via ULPI

ZIPRev 1.0Aug 28, 2013366.1 KBAN11309English
Application Note
LPC1800/LPC4300 One-Time Programmable (OTP) configuration

ZIPRev 1.0Aug 23, 2013232.2 KBAN11292English
Application Note
Using the SCT in LPCXpresso, Keil, and IAR

ZIPRev 1.0Aug 9, 20134.2 MBAN11161English
Application Note
Wrting a flash programming algorithm for unsupported devices

ZIPRev 1.0Aug 9, 2013398.5 KBAN11285English
Application Note
Using SPIFI on LPC1800 and LPC4300

ZIPRev 1.0Aug 9, 20137.2 MBAN11206English
Application Note
How to implement the PMBus software stack

ZIPRev 1.0Jul 22, 20131.1 MBAN11318English
Application Note
Bootmode jumper settings for LPC1800 and LPC4300

PDFRev 1.0Jul 23, 2012247.0 KBAN11239English
Application Note
UUencoding for UART ISP

PDFRev 1.0Jul 6, 2012142.1 KBAN11229English
User Guide
LPC18xx Arm^® Cortex^®-M3 microcontroller

PDFRev 3.1Sep 13, 201911.9 MBUM10430English

Account Required
Brochure
NXP^®'s Flexible camera interface

PDFRev 1.0Mar 4, 2014910.0 KB75017537English
Errata
Errata sheet LPC1850, LPC1830, LPC1820, LPC1810

PDFRev 7.2Feb 5, 20201.4 MBES_LPC18X0English
Package Information
plastic low profile quad flat package; 144 leads; body 20 x 20 x 1.4 mm

PDFRev 1.0Feb 8, 2016830.0 KBSOT486-1English
Training Presentation
Driving LPC1700/LPC1800/LPC4300 with EPSON Crystals

PDFRev 1.1Nov 27, 2015213.7 KBR_10076English
Supporting Information
Connecting a USB power switch to the LPC18xx / LPC43xx

PDFRev 1.0Mar 6, 201376.0 KBTN00007English
Supporting Information
LPC1800 and LPC4300 MxMEMMAP memory map

PDFRev 1.0Dec 6, 2012148.0 KBTN00006English
Supporting Information
Footprint for wave soldering

PDFRev 1.0Oct 8, 200911.2 KBHTQFP-HLQFP-LQFP-MSQFP-WAVEEnglish

Show All

Design Resources

Design Files

Quick reference to our design files types.

5 design files

Receive the full breakdown. See the product footprint and more in the eCad file.

Models
IBIS models for LPC18x0 and LPC43x0 FBD208

ZIPRev 2Mar 25, 2020 16:19:00377.1 KBIBIS_LPC18x0_LPC43x0FBD208
DownloadToggle Dropdown
- Add to Queue
- Remove from Queue
- Recommended for large file sizes.
- View Queue
Models
BSDL for LPC18xx and LPC43xx

ZIPRev 2Feb 27, 2018 11:57:00269.0 KBBSDL_LPC18XX_43XX

Account Required
DownloadToggle Dropdown
- Add to Queue
- Remove from Queue
- Recommended for large file sizes.
- View Queue
Models
IBIS models for LPC18x0 and LPC43x0 FET256-180-100

ZIPRev 1Jun 13, 2017 16:19:00380.3 KBIBIS_LPC18x0_43x0FET256-180-100

Account Required
DownloadToggle Dropdown
- Add to Queue
- Remove from Queue
- Recommended for large file sizes.
- View Queue
Symbols and Footprints
LPC43xx/LPC18xx Eagle symbols

ZIPRev 0Jun 3, 2016 00:00:0014.9 KBLPC43XX-EAGLE-SYM

Account Required
DownloadToggle Dropdown
- Add to Queue
- Remove from Queue
- Recommended for large file sizes.
- View Queue
Symbols and Footprints
LPC18XX_43XX_SCH Orcad Symbols

ZIPRev 1.0Apr 30, 2018 12:37:0052.2 KBLPC18XX_43XX_SCH_1

Account Required
DownloadToggle Dropdown
- Add to Queue
- Remove from Queue
- Recommended for large file sizes.
- View Queue