Receive the full breakdown. See the product footprint and more in the eCad file.
Compact List
I2C-Bus Controlled 4 x 50 W Power Amplifier
The TDF8544 is one of a new generation of complementary quad Bridge-Tied Load (BTL) audio power amplifiers intended for automotive applications. It has full I²C-bus controlled diagnostics, including start-up diagnostics. The TDF8544 can operate at a battery voltage as low as 6 V making this amplifier suitable for stop/start-car operation.
The amplifier uses a complementary DMOS output stage in a Silicon-On-Insulator (SOI)- based BCD process. The DMOS output stage ensures a high power output signal with advanced sound quality. The SOI-based BCD process ensures a robust amplifier, where latch-up cannot occur, with good separation between the four independent channels, with every component isolated and without substrate currents.
Product Details
Features
Key Features
- Stop/start-car prepared: keeps operating without audible disturbance during engine start at a battery voltage as low as 6 V
- Operates in either legacy (non I²C-bus) or I²C-bus modes (3.3 V and 5 V compliant)
- Four hardware-programmable I²C-bus addresses
- Can drive 2 Ω and 4 Ω loads
- Speaker fault detection
- Start-up diagnostics with load detection: open, short, present; filtered for door-slam and chatter relays
- AC load (tweeter) detection with low and high current mode
- Gain select after start-up without audible disturbance
- Independent selectable soft mute of front and rear channels
- Programmable gain (26 dB and 16 dB), independently programmable for the front and rear channels
- Line driver mode supports engine start at a battery voltage as low as 6 V (16 dB and mid-tap voltage 0.25VP)
- Programmable clip detect: 2 %, 5 % or 10 %
- Programmable thermal pre-warning
- Pin STB can be programmed/multiplexed with second-clip detect
- Clip information of each channel can be directed separately to pin DIAG or pin STB
- Independent enabling of thermal-, clip- or load fault information (short across the load or to VP or to ground) on pin DIAG
- Loss-of-ground and open VP safe (minimum series resistance required)
- All amplifier outputs short-circuit proof to ground, supply voltage and across the load (channel independent)
- All pins short-circuit proof to ground
- Temperature controlled gain reduction to prevent audio holes at high junction temperatures
- Programmable low battery voltage detection to enable 7.5 V or 6 V minimum battery voltage operation
- Over-voltage protection (load-dump safe up to VP = 50 V) with over-voltage pre-warning at 16 V
- Offset detection
Buy/Parametrics
2 results
Include 0 NRND
Part | Order | CAD Model | Remark | Status | RMS power (W) | Gain (dB) | Amplifier type | Channel configuration | Package Type |
|---|---|---|---|---|---|---|---|---|---|
I2C Bus diagnostic | Active | 4 x 28 | 26 | class-AB | BTL/quad | RDBS27P | |||
I2C Bus diagnostic | Active | 4 x 28 | 26 | — | BTL/quad | HSOP36 |
4 documents
Compact List
Brochure (1)
Package Information (3)
Design Resources