Design Files
Receive the full breakdown. See the product footprint and more in the eCad file.
8-bit EEPROM with LIN S08EL and S08SL MCUs
S08EL and S08SL 8-bit microcontrollers with embedded Follower LIN Interface Controller (SLIC) and EEPROM help to increase LIN follower performance and reduce development time. NXP® Semiconductors's 8-bit EL and SL families of microcontrollers (MCUs) are designed for LIN follower and general market applications. The EL family is positioned as higher end, offering higher memory and more peripherals, while the SL family is intended for more cost-sensitive applications.
An application focus area of the EL and SL families is' Local Interconnect Network (LIN). LIN is a UART-based, single-leader, multiple-follower networking architecture originally developed for automotive sensor and actuator networking applications.
Product Details
Features
8-Bit HCS08 Central Processing Unit (CPU)
- Up to 20 MHz internal bus (40 MHz HCS08 Core) frequency offering 2.7 to 5.5V across temperature range of -40°C to 85°C
On-Chip Memory
- Up to 32K flash read/program/erase over full operating voltage and temperature
- Up to 512 Bytes EEPROM
Power Saving Modes
- Two very low-power stop modes
- Reduced power wait mode
- Very low-power real-time interrupt for use in run, wait, and stop
Clock Source Options
- Oscillator (XOSC) — Loop-control Pierce oscillator; Crystal or ceramic resonator range of 31.25 kHz to 38.4 kHz or 1 MHz to 16 MHz
- Internal Clock Source (ICS) — FLL modes; Internal reference clock with trim adjustment
Periperals
- Follower LIN interface controller (SLIC)— Supports LIN 2.0 and SAE J2602 protocols; up to 120 kbps, full LIN message buffering, automatic bit rate and frame synchronization, checksum generation and verification, UART-like byte transfer mode
- Analog to digital converter (ADC)—Up to 16-channel, 10-bit resolution
- Serial communications interface (SCI) —with LIN 2.0 Protocol and SAE J2602 compliance; Leader extended break generation; Follower extended break detection; LIN follower supplement on SCI1; Automatic baud rate correction; Message time-out detection
- RTC—(Real-time counter) 8-bit modulus counter with binary or decimal based prescaler; External clock source for precise time base, time-of-day calendar or task scheduling functions; Free running on-chip low power oscillator (1 kHz) for cyclic wake-up wit
Input/Output
- 16 interrupt pins with selectable polarity
- 22 general purpose input/output (GPIO)s
System Protection
- Low-voltage detection with reset or interrupt; selectable trip points
- Flash block protection
- EEPROM block protect
Hardware Development Support
- Single-wire background debug interface
- On-chip in-circuit emulator (ICE) debug with real time bus capture
Product Longevity Program
- This product is included in NXP product longevity program, with assured supply for a minimum of 15 years after launch
Buy/Parametrics
| | | | | |
|---|---|---|---|---|---|
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
Documentation
Quick reference to our documentation types.
1-5 of 42 documents
-
Fact Sheet
S08EL and SL 8-bit I and MM Microcontrollers FactsheetFeatured
-
Data Sheet
Addendum to MC9S08EL32 Series Data SheetFeatured
-
Application Note
Migration Guide from S08 to Kinetis L Series MCUsFeatured
1-5 of 42 documents
-
Fact Sheet
S08EL and SL 8-bit I and MM Microcontrollers FactsheetFeatured
-
Data Sheet
Addendum to MC9S08EL32 Series Data SheetFeatured
-
Application Note
Migration Guide from S08 to Kinetis L Series MCUsFeatured
Design Resources
Hardware
Quick reference to our
board types.
5 hardware offerings
-
Emulators, Probes, and ProgrammersUniversal Multilink Development InterfaceFeatured
-
Evaluation and Development BoardsS08EL/SL Demonstration BoardFeatured
-
Emulators, Probes, and ProgrammersPEmicro Cyclone programmer
-
Additional hardware available. View our featured partner solutions.
-
Emulators, Probes, and ProgrammersPEmicro Cyclone FX programmer
-
Emulators, Probes, and ProgrammersUniversal Multilink FX High-Speed Development Interface
Software
Quick reference to our software types.
1-5 of 11 software files
-
Development IDEs and Build Tools
CodeWarrior® for Microcontrollers (Classic IDE) - RS08/HC(S)08, ColdFire V1 v6.3Featured
-
Development IDEs and Build Tools
CodeWarrior® for MCUs (Eclipse IDE) - ColdFire®, 56800/E DSC, Qorivva® 56xx, RS08/S08, S12Z - 11.1Featured
-
Configuration Tools
Processor Expert® Software – Component Development Environment v1.0.4
-
Additional software available. View our featured partner solutions.
-
Configuration Tools
Embedded Component: NXPAnalogComp
-
BSPs and Device Drivers
LIN2.x and SAE J2602 Stack
Note: For better experience, software downloads are recommended on desktop.
Engineering Services
To get further assistance directly from NXP, please see our Engineering Services.
4 engineering services
-
Independent Design House (IDH)
Hardware/Software Engineering Services
-
Independent Design House (IDH)
Embedded firmware consulting
-
Independent Design House (IDH)
Hardware/Software development and testing
.svg)
-
Independent Design House (IDH)
EMI/EMC Assessment and compliance
To find additional partner offerings that support this product, visit our Partner Marketplace.